Renesas H8S User Manual download pdf (Page 14)

Direct Drive LCD Design Guide

entire panel to fill with valid pixels is the maximum refresh rate. Displays in existing media systems usually

have refresh rates between 48Hz and 120Hz to avoid visible flicker.

HSync, VSync and Dot Clock are all generated using TPU channels of the H8S or H8SX microcontrollers.

The TPU allows timer compare actions which synchronize these signals to the ExDMA request line. This

ensures that the clocks are generated when valid data is available on the bus.

3.1.5 Data Enable

Many panels require an additional signal to frame the valid data – this enable signal is sent at the time the

valid data is latched onto the bus – the panel will then clock in the data on the next edge of Dot Clock. It

provides added synchronization for the timing of data, but this signal can often be left in the active state if

the Dot Clock synchronization to the data is predictable.

3.1.6 RGB (Red Green Blue) Data

The data is presented to the panel in parallel. LCD panels have connections for 6 or 8bits of data for each

color totaling 18 or 24bits of color resolution. Our solution uses a 16bit data bus, so the most significant

bits of the data are presented to the panel. RGB 5-6-5 is the most common 16 bit solution. The least

significant bits can be tied low, or better still, to the MSB which would give a slightly improved range over

tying to ground.

Specifically with respect to Renesas H8S and H8SX devices, we use the ExDMA module to control the

data bus transfers.

3.1.7 Touch Screen

Our support is currently for popular resistive touch screen panels which have 4 connections (endpoints of

an X axis resistance and Y axis resistance). These inputs provide resistances proportional to the touched

location particular X and Y coordinates on the panel.

The host system (microcontroller plus logic) drives the resistive endpoints with a known reference voltage,

and the level on the channel is read into an analog to digital converter (ADC). With calibration and scaling

in the microcontroller driver code, it is possible to pinpoint the area of the panel that was touched. Action

can be taken accordingly.

An example of interface circuitry between the MCU and touch-screen is shown in Figure 6 below.

VCC

Y_DRIVE

X_D R I VE

TOUCH_YU

TOUCH_XL

TOUCH_YL

TOUCH_XR

10nF

U1D

HC126A

12 11

U1C

HC126A

9 8

10nF

U1A

HC126A

2 3

R11

DNF

10nF

DNF

MOLEX_52044

DNF

R10

DNF

U1B

HC126A

5 6

Figure 8 Touch Screen Circuit

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Comments to this Manuals

No comments

Renesas H8S User Manual Page 14

Comments to this Manuals