H8S/2237 Series TQFP-100G User System Interface Cable (HS2237ECN61H) for E6000 Emulator User’s Manual HS2237ECN61HE(C)
2.2.1 Installing IC Socket 1. Confirming the location of IC socket 6 UTIONCA After confirming the location of pin 1 on the IC socket, apply
2.2.2 Inserting Cable Head 7 UTIONCA Check the location of pin 1 before inserting. Align pin 1 on the IC socket for a TFP-100G package on the u
Fasten the user system interface cable head to the IC socket for a TFP-100G package on the user system with the four screws (M2 x 10 mm) provided. Ea
2.2.4 Connecting Cable Body to Cable Head Cable bodyCable headRemove jigPush the remove jigRemovingUser systemConnect the cable body to the cable hea
2.3 Recommended Dimensions for User System Mount Pad Figure 6 shows the recommended dimensions for the mount pad (footprint) for the user system with
2.4 Dimensions for User System Interface Cable Head The dimensions for the user system interface cable head are shown in figure 7. Unit:
2.5 Resulting Dimensions after Connecting User System Interface Cable The resulting dimensions, after connecting the user system interface cable head
Section 3 Installing the MCU to the User System 13 UTIONCA 1. Check the location of pin 1 before inserting. 2. Use the screwdriver provided fo
MCUPin 1IC socket (NQPACK100SEmanufactured by Tokyo Eleteck Corporation)User systemScrews (M2 x 6 mm)Socket cover Figure 9 Installing MCU to User Sys
Section 4 Verifying Operation 1. When using the E6000 emulator for the H8S/2633 series, turn on the emulator according to the procedures described i
Cautions 1. Renesas neither warrants nor grants licenses of any rights of Renesas’s or any third party’s patent, copyright, trademark, or other intel
Section 5 Notice 1. Make sure that pin 1 on the user system IC socket is correctly aligned with pin 1 on the cable head before inserting the cable h
i Preface Thank you for purchasing this user system interface cable (HS2237ECN61H) for the Renesas’s original microcomputer H8S/2237 series. The HS22
ii Contents Preface ...i Section 1 Configurati
Section 1 Configuration 1 UTIONCA Use an NQPACK100SE socket (manufactured by Tokyo Eletech Corporation) for the TFP-100G package IC socket
To emulator stationCable bodyScrews (M2 x 6 mm)Socket coverUser systemIC socketCable headScrews (M2 x 10 mm)(for fastening cable head) Figure 1 HS223
3 Table 1 lists the HS2237ECN61H components. Please make sure you have all of these components when unpacking. Table 1 HS2237ECN61H Components No.
Section 2 Connection Procedures 2.1 Connecting User System Interface Cable to Emulator Station WARNING Always switch OFF the user system and the
2.2 Connecting User System Interface Cable to User System WARNING Always switch OFF the user system and the emulator product before the USER SY
Comments to this Manuals