Renesas 4513 Technical Information download pdf (Page 9)

( 7 / 42 )

IMPORTANT

Notes on Differences between Actual MCU and Emulator:

• Emulator operation differs from emulation of a mask MCU, as listed below. For details refer to

"Chapter 5. Precautions to Be Taken When Debugging".

(1) Reset condition

(2) Initial values of internal resource data at power-on

(3) Internal ROM and RAM capacities, etc.

(4) Electrical characteristics

(5) Operation in the power-down mode

(6) Operation of the watchdog timer function

(7) Port I/O Timing

(8) Pullup transistor control

• Therefore, always be sure to evaluate your system with an evaluation MCU (onetime version).

Also, be sure to perform board-mounted evaluation with ES (Engineering Sample) version MCU

to make final confirmation of device operation before starting mask production.

Note on the Target System:

• Make sure that the target's supply voltage is + 3.0 V or + 5.0 V. Therefore the target's supply voltage

should be in the range of + 3.0 V ±10% or + 5.0 V ±10%.

Notes on Connecting the Target System:

• When connecting the emulator probe, be careful to the wrong connection.

• When connecting the emulator probe, be careful to the warp of the cable. The warp may cause

breaking the wire.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Renesas 4513 Technical Information Page 9