14. Select FF000 for the Firmware location for the program. It
is recommended that the E8a firmware location is towards
the top of the memory map.
15. Select 7F00 for the Work RAM location. It is
recommended that the Work RAM is towards the top of
the memory map.
16. Ensure that the checkbox “Debugging of program that
uses WDT” is not checked.
17. Select the ‘MCU Setting’ tab..
18. Select the processor mode “Single-Chip Mode”.
19. Select “PM13 …”.
20. Clear “PM10 …”.
21. Click <OK>.
8
Comments to this Manuals