Renesas RSKM16C6NK Technical Information download pdf (Page 11)

5.2. Connecting the debugger

For this tutorial it is not necessary to provide an external power supply to the board. The power will be obtained from the USB port. Please

be aware that if you have too many devices connected to your USB port it may be shut down by windows. If this happens remove some

devices and try again. Alternatively provide an external power source taking care to ensure the correct polarity and voltage.

The Quick Start Guide provided with the RSK board gives detailed instructions on how to connect the E8a to the host computer. The

following assumes that the steps in the Quick Start Guide have been followed and the E8a drivers have been installed.

4. Fit the LCD module to J11 on the RSK, so it lies above J3. Insure all the pins of the connector are correctly inserted in the

socket.

5. Connect the E8a module to the USB port on your computer.

6. Connect the E8a module to the target hardware ensuring that it is plugged into the connector marked E8 which is nearest

the power connector.

7. If supplying external power to the board this can be turned on now.

5.3. Connecting to the target with the E8a

This section will take you through the process of connecting to the device, programming the Flash and executing the code.

8. Select the ‘SessionM16C_E8a_System’ debug session.

9. Click the <Connect> button on the debug

toolbar

Note: The first time the E8a is connected in the life of a

Workspace, the ‘Emulator mode’ wizard will be shown

instead of the ‘Emulator Setting’ dialog illustrated, the

settings to choose are identical.

10. Select the correct Device (M306NKFJ for M16C/6NK)

11. Select ‘Erase Flash and Connect’

12. If the E8a is to provide the power to the RSK board, select

‘Power Target from Emulator’ and choose the ‘5.0V’

option.

13. Click <OK>.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Renesas RSKM16C6NK Technical Information Page 11