Renesas REG10J0020-0200 User Manual

To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C

Chapter 4.User Circuitry 4.1.Fitting the Target RSK to the RSK LCD application board The board is supplied with 2x 24 way sockets, 2x 26 way sockets

Segment L K J I DP C BADEFXMNGHBit number 7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0 Hex value for RAM A 0 1 0 0 0 1 1 1 0 1 1 0 0 0 1 0 476

4.3.Coin Cell and switch. The board includes a coin cell holder to hold a 2032 3.6V coin cell. To power the attached RSK from this cell the switch mu

Chapter 5.Headers 5.1.Application Headers This information is supplied for reference. Only JA1 pin 3 (battery supply voltage to RSK) and the ground p

JA2 Pin Generic Header Name CPU board Signal Name Pin Header Name CPU board Signal Name 1 Open drain RESn 2 External Clock Input EXTAL 3 Open

JA6 Pin Generic Header Name CPU board Signal Name Pin Header Name CPU board Signal Name 1 DMA DREQ 2 DMA DACK 3 DMA TEND 4 Standby (Open dra

Table 5-5 below shows the LCD header connectionsJA4 Pin Generic Header Name Signal Name Pin Header Name Signal Name 1 V0 V0 2 V1 V1 3 V2 V2

Chapter 6.Code Development RSKs with appropriate LCD connections will include suitable sample software to drive the LCD on this board. Section 4.2 in

Chapter 7.Additional Information For details on how to use High-performance Embedded Workshop (HEW), refer to the HEW manual available on the CD or f

Renesas Starter Kit LCD Application Board User's Manual Publication Date Rev.2.00 29.11.2007 Published by: Ren

Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang

1753, Shimonumabe, Nakahara-ku, Kawasaki-shi, Kanagawa 211-8668 JapanRenesas Starter LCD Application BoardREG10J0020-0200User’s Manual

Renesas Starter Kit LCD Application BoardUser’s ManualUser’s ManualRev.2.00 2007.11RENESAS STARTER KIT

Table of Contents Chapter 1. Preface...

Chapter 1. Preface Cautions This document may be, wholly or partially, subject to change without notice. All rights reserved. Duplication of this d

Chapter 2.Purpose This RSK Application Board is an evaluation tool for Renesas microcontrollers with an LCD driver interface. It is used in conjuncti

Chapter 3.Board Layout 3.1.Component References The following diagram shows the component references for the board. Figure 3-1: Component References

3.2.Board Component functions The following diagram the shows the functions of the components on the board. JA5 JA1JA6 JA2Application Board Interfac

3.3.Board Dimensions The following diagram gives the board dimensions and connector positions. All through hole connectors are on a common 0.1” grid