Renesas H8S/2169 Series Technical Information download pdf (Page 11)

2.2 Connecting User System Interface Cable to User System

WARNING

Always switch OFF the user system and the emulator

product before the USER SYSTEM INTERFACE CABLE

is connected to or removed from any part. Before

connecting, make sure that pin 1 on both sides are correctly

aligned. Failure to do so will result in a FIRE HAZARD and

will damage the user system, the emulator product, and the

expansion I/O board or will result in PERSONAL

INJURY. The USER PROGRAM will be LOST.

To connect the cable head to the user system, follow the instructions below.

2.2.1 Installing IC Socket

After checking the location of pin 1 on the IC socket fasten it to the user system before soldering.

CAUTION

After confirming the location of pin 1 on the IC socket,

apply epoxy resin adhesive to the end of the four projections

at the bottom of the IC socket, and fasten it to the user

system.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

No comments

Renesas H8S/2169 Series Technical Information Page 11