To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C
IV SAFETY PAGE READ FIRST • READ this user's manual before using this emulator product. • KEEP the user's manual handy for future reference
V WARNING Observe the precautions listed below. Failure to do so will result in a FIRE HAZARD and will damage the user system and the emula
VI CAUTION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
i Preface Thank you for purchasing the H8S/2628, H8S/2615 series E6000 emulator. The H8S/2628, H8S/2615 series E6000 emulator (hereafter referred
ii Contents Section 1 Overview...1 1.1 Environment Condit
iii Figures Figure 2.1 Default User System Interface Circuit...4 Figure 2.2 Us
1 Section 1 Overview The H8S/2628, H8S/2615 series E6000 emulator (hereafter referred to as the E6000) is an efficient software and hardware devel
2 Table 1.3 H8S/2615 Series MCU and User System Interface Cable No. MCU Type Number Package E6000 User System Interface Cable 1 HD64F2615 80-pi
3 Section 2 User System Interface All user system interface signals are directly connected to the MCU in the E6000 with no buffering except for t
4 Default: 47 kUser system interface cableMCU47 VccΩΩ Figure 2.1 Default User System Interface Circuit Mode Pins (MD2, MD1 and MD0), NMI, STBY and
Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang
5 AN0-AN15, AVcc, AVss and Vref: User system interface cableUser system interface cableH8S/2628 seriesH8S/2615 seriesMCUMCUAVccVrefAVss0.022 Fµ0.
6 Section 3 Notes on Use 3.1 I/O Register Differences between Actual MCU and E6000 In the E6000, one evaluation chip emulates several types of MC
7 3.6 Procedure for Applying the Power When the user system is connected to the emulator, apply the power of the user system and then start the emu
8 Section 4 HDI Parameters 4.1 Address Areas Table 4.1 lists the parameters for address areas (Area) that can be specified with HDI command line i
9 4.2 Access Status Table 4.2 lists the parameters for access status (Status) that can be specified with HDI command line interface or displayed as
10 4.3 I/O Modules Table 4.3 lists the parameters for I/O module selection in the custom setting of the HDI Configuration window. Table 4.3 I/O Mod
11 Section 5 Diagnostic Test Procedure This section describes the diagnostic test procedure using the E6000 test program. 5.1 System Set-Up for T
12 5.2 Diagnostic Test Procedure Using the Test Program Insert the CD-R (HS2628EPI61SR supplied with the E6000) into the CD-ROM drive of the host c
13 The following messages are displayed during the test. There are 19 steps in this test. The following messages are displayed during the test. Mes
14 1) Test Register A) IDR0 Register ...OK B) PAGE Register ...OK C
Regarding the change of names mentioned in the document, such as Hitachi Electric and Hitachi XX, to Renesas Technology Corp.The semiconductor operati
15 C) Decode Test page[H'000 - H'04f](Upper 32 K) ...OK Shows the results of decoding test for the trace RAM (last half) in the E6
16 9) Test Keybreak A) Key Break ...OK Shows the check results for the forced break controlling circuits
17 15) Test Emulation Monitor A) EMA23-EMA0 ...OK B) ACST2-ACST0 ...
18 19) Test H8S/2628 Register Read/Write A) Register Read ...OK B) Register Read/Write Test ...
Cautions Keep safety first in your circuit designs! 1. Renesas Technology Corporation puts the maximum effort into making semiconductor products bett
H8S/2628, H8S/2615 SeriesE6000 Emulator HS2628EPI61HSupplementary InformationUser’s Manual Rev.3.0 2003.03
Cautions 1. Hitachi neither warrants nor grants licenses of any rights of Hitachi’s or any third party’s patent, copyright, trademark, or other in
I IMPORTANT INFORMATION READ FIRST • READ this user's manual before using this emulator product. • KEEP the user's manual handy for future
II LIMITED WARRANTY Hitachi warrants its emulator products to be manufactured in accordance with published specifications and free from defec
III State Law: Some states do not allow the exclusion or limitation of implied warranties or liability for incidental or consequential damages, so
Comments to this Manuals