Renesas PROM Programming Adapter PCA7427G02 Technical Information download pdf (Page 17)

( 14 / 14 )

7.2 MCU Does Not Function Normally

The program operates normally on the emulator, but when the MCU that has normally been written

is attached the same program does not function normally.

(1) Is the offset address specified correctly when copying data into the PROM programmer?

(2) In the emulator, NOPs are often inserted in the area where the program has not been read, therefore

the program happens to appear functioning normally even though it may have gone wild. Check

your program again.

(3) The emulator and the actual MCU may differ in characteristics. Consult the user's manual of the

emulation pod to check for differences in characteristics again.

7.3 Other Precautions

7.3.1 About the Recommended PROM Programmers

Not all PROM programmers available on the market can be checked to see if they function properly.

There are several PROM programmers that we have verified to function properly. These products are

listed as recommended PROM programmers in "5. Recommended PROM Programmers". Other

PROM programmers may also be used providing that you verified them to function properly.

Note: No matter which type of PROM programmer you use, it is necessary to verify completion of

programming by executing screening, etc. that are stipulated for each MCU used.

7.3.2 About Reading Out of Device Identification Code *

Please do not use the PROM programmer's device identification code readout function.

Using this function may break down the MCU. The device identification code is included in EPROM

to indicate the manufacturer code and device code; it is not included in the MCU.

Depending on PROM programmer manufacturers, this may be referred to by another name (e.g.

ID code).

1 2 ... 12 13 14 15 16 17 18

No comments

Renesas PROM Programming Adapter PCA7427G02 Technical Information Page 17