80
5.3 Program Execution
5.3.1 Execution
Table 5.6 shows the main forms of program execution.
Table 5.6 Program Execution
Form Function Procedure
Click the [Go] button
Normal execution Executes the user program from the
current PC (program counter)
address.
Select [Go] from the [Run] menu
Click the [Reset Go] buttonExecution from the
reset vector
Inputs the RES signal to the MCU,
then executes the user program from
the reset vector.
Select [Reset Go] from the [Run]
menu
Setting a program
counter to a
specified address
Sets the program counter to the
specified address.
Place the mouse cursor on the
[Source] window. Then click the [Set
PC Here] button or select [Set PC to
Cursor] from the [Run] menu
Execution to a
specified address
Executes the user program to the
specified address.
Place the mouse cursor on the
[Source] window. Then click the [Go
to Cursor] button or select [Go to
Cursor] from the [Run] menu
Specifies the end address, and
executes the user program up to that
address.
Select [Run…] from the [Run] menu,
specify a start address for [Program
Counter] in the [Run] dialog box,
specify an end address for [Stop At]
in the [Run] dialog box, then click
the [Go PC] button. More than one
address can be specified as an end
address.
Note: The function, which is executed by placing the mouse cursor on the specified address in
the [Source] window and then selecting the [Go to Cursor] button, or by selecting [Go to
Cursor] from the [Run] menu, uses a channel for the on-chip break. Therefore, when 12
channels of the on-chip break are used with the break condition, this function cannot be
used.
Comments to this Manuals