Renesas Single-Chip Microcomputer M37531T-ADS User Manual download pdf (Page 21)

M38000T2-CPE User’s Manual 2. Setup

REJ10J0301-0400 Rev.4.00 March 01, 2006

Page 21 of 78

2. Setup

This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change

settings.

2.1 Flowchart of Starting Up the Emulator

The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the

emulator does not start up normally, refer to “5. Troubleshooting” (page 72).

Check the package components. Refer to “1.1 Package Components (page 13).

↓

User registration Refer to “User Registration” (page 11).

↓

Install or upgrade the C compiler and

emulator debugger.

Install it from the included CD-ROM.

↓

Set the emulator MCU type selection switch.

Set the emulator MCU type selection switch according to your

emulator MCU type.

↓

Connect the USB interface cable.

Connect the USB interface cable to the USB interface connector

(J2) of the emulator and the USB port of the host machine.

↓

Connect the power supply for the emulator.

Connect the power supply for the emulator to the power connector

(J1). Power supply for the emulator is 5.0 V±5％, 2 A

↓

Connect the user system.

Connect the user system to the emulator.

Connect the separately available converter board when necessary.

↓

Connect the target status cables.

Connect the Vcc, GND and RESET clips of target status cables to

the Vcc, GND and RESET pins on the user system.

↓

Turning on the power supply.

Turn on the power to the emulator and the user system as

simultaneously as possible.

↓

Check the LED display of the emulator.

Check that the system status LED, and POWER and CLOCK of

target status LED are lighting. When the user system is not

connected, the POWER of target status LED does not light up.

↓

Start up the emulator debugger from the High

performance Embedded Workshop.

Start up the High-performance Embedded Workshop, then, start up

the emulator debugger.

↓

Set the operating environment

of the emulator debugger.

Set the INIT dialog box and MCU Setting dialog box of the

emulator debugger.

↓

Debug a program with various functions of

the emulator debugger.

For how to use the High-performance Embedded Workshop

emulator debugger, refer to the online manual.

Figure 2.1 Flowchart of starting up the emulator

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 77 78

Comments to this Manuals

No comments

Renesas Single-Chip Microcomputer M37531T-ADS User Manual Page 21

Comments to this Manuals

Related products and manuals for Networking Renesas Single-Chip Microcomputer M37531T-ADS