M38000T2-CPE User’s Manual 2. Setup
REJ10J0301-0400 Rev.4.00 March 01, 2006
Page 33 of 78
Table 2.4 Error LED display in the self-check and how to remedy it (2/2)
: ON
: OFF
: Blinking
Example
POWER CLOCK RESET RUN
Problem & Remedy
The emulator system is not working properly.
- The emulator or emulator MCU may be damaged. Contact your local distributor.
IMPORTANT
Notes on the Self-check:
z Be sure to connect the user system before executing the self-check.
z If the self-check does not result normally, the emulator or emulator MCU may be damaged. Then, contact your
local distributor.
z Depending on the MCU type, the registers will be altered only once after power-on. In that case, temporarily
turn off the power for the emulator system and user system after self-check has finished normally and then turn
it back on again.
Comments to this Manuals