Renesas Single-Chip Microcomputer M37531T-ADS User Manual download pdf (Page 44)

M38000T2-CPE User’s Manual 3. Usage (How to Use the Emulator Debugger)

REJ10J0301-0400 Rev.4.00 March 01, 2006

Page 44 of 78

3.6 Trace Window

(1) Trace window

1. Opening the trace window

2. Trace window

Trace window

The trace window is used to show the results of real-time

trace measurements. It has the following four display

modes:

- Bus mode

Bus information per cycle can be inspected. The contents

are displayed in order of execution paths.

- Disassemble mode

The execution paths of the executed instructions can be

inspected. The contents are displayed in order of

execution paths.

- Source mode

The execution paths of the source program can be

inspected.

Operating buttons of the tool bar can reference the

execution paths.

- Data access mode

Data read/write cycles can be inspected. In addition to the

data access information, the window can display the

source line information in combination with it.

The trace window shows the measurement result when a

real-time trace measurement has finished. The trace window

remains blank until the real-time trace measurement in

progress finishes.

Trace window

Clicking this button opens the trace window.

Or you can select “Trace” from “Trace” of “Display” menu

for the same effect.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 77 78

No comments

Renesas Single-Chip Microcomputer M37531T-ADS User Manual Page 44