Renesas Single-Chip Microcomputer M37531T-ADS User Manual download pdf (Page 27)

M38000T2-CPE User’s Manual 2. Setup

REJ10J0301-0400 Rev.4.00 March 01, 2006

Page 27 of 78

2.6.3 Connecting the User System

To connect the emulator MCU and user system, a converter board according to the package is required. For details on

connecting to the user system,

go to the M38000T2-CPE page from the following Renesas Tools Homepage and click

"Options" on the left menu to select the target MCU.

http://www.renesas.com/en/tools

When you have not prepared the user system, you can use a temporary target board (separately available).

2.6.4 Connecting the Target Status Cables

Connect the VCC, GND and RESET clips on the tip of the target status cables to the VCC, GND and RESET pins of the user

system respectively.

(1) VCC cable (red)

(2) GND cable (black)

(3) RESET cable (white)

M38000T2-CPEC REV.B

M38000T2-CPE

COMPACT EMULATOR

STATUS

SYSTEM

MADE IN JAPAN

STATUS

TARGET

POWER

5.0V

USB

RESET

POWER

SAFE

POWER

CLOCK

RESET

RUN

RLSS/RLFS

RSS/RFS

WHITE:RESET

RED:VCC

BLACK:GND

TARGET

GOOD

Omitted

RESET VCC GND

Red

White

Black

User system

Figure 2.8 Connecting the Target Status Cables

CAUTION

Notes on Connecting the User System:

z Take care not to attaché the converter board in a wrong direction. It may cause a fatal damage to the compact

emulator.

z Always shut OFF the emulator and the user system when connecting and disconnecting the user system.

Otherwise the internal circuit may cause a break.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 77 78

Comments to this Manuals

No comments

Renesas Single-Chip Microcomputer M37531T-ADS User Manual Page 27

Comments to this Manuals

Related products and manuals for Networking Renesas Single-Chip Microcomputer M37531T-ADS